12V 35W canbus slim ballast
Product Description
A new HID canceller ballast which is much better than canceller kit we made before, and canceller functions build inside the ballast. (include radio noise)
There are three problems when installing normal ballasts in some vehicles.
1) Headlights Keep flickering.
2) Lights go-off when turn on the lamp.
3) Headlights work ok, but warning light or error light appeared in the instrument board.
All above 3 problems will be ok when installing our canceller ballasts.
The advantage of canceller ballast describes below:
1. Thisballast can work with all 12v normal vehicles on hi beam or low beam
2. This ballast can work with BMW or Mercedes or Audi...etc,
People no need to worry about the solutions of the above 3 problems.
No need to use external resistor or relay...etc.
| Can-bus BALLAST SPECIFICATIONS |
| General spec. |
| 1.Operation temperature |
-40ºCto +85ºC |
| 2.Steady state light output |
>3300 lumens(for 4300k) typical,bulb type dependent |
| 3.Turn on light output power |
35W after 47 sec "> >35W after 47 sec |
| 4.Expected ballast life |
2500 hours typical "> >2500 hours typical |
| 5.Cooling |
Conductively cooled |
| Electrical output |
| 6.Output waveform |
400 �� 50Hz square wave |
| 7.Steady state output power |
35�� 0.5W |
| 8.Open circuit protection(lamp is on) |
Latch off ballast after 2 sec max |
| 9.Short circuit protection |
Latch off ballast after 150msec max |
| 10.Start current |
3.5A~4.5A initial bulb on . |
| 11.Maximum output power |
100W |
| 12.Steady state output volts |
68V to 130V |
| 13.starting voltage |
<23000V |
| Electrical input |
| 14.Operation voltage |
DC 9V to 16V |
| 15.Max. in rush current |
<9A (5ms) after power on |
| 16.Max. Steady state input power |
50W |
| 17.Input turn off |
>16V ��<9V ( Option : > 32V ��< 7.5V with low voltage function) |
| 18.Input turn on |
>16V ��<9V ( Option : > 29V ��< 8.5V with low voltage function) |
| 19.Normal input current |
3.5A��0.1A(DC 12.4V) |
| 20.Reverse voltage protection |
No damage to ballast with 1V ~ 16V |
| PS:can-bus ballast must screw tightly on the cars |
